Reference
Every symptom, and what it usually means.
The full list behind the checker above. If you would rather read than click, everything it can tell you is written out here.
Book it soon
Creosote odor, amplified by humidity
A smell coming from the fireplace → On hot or humid days, even with no fire
A sharp, smoky, barbecue-like smell that shows up on hot humid days is almost always creosote residue in the flue reacting to moisture in the air. The smell is a symptom; the deposit itself is the reason it matters, because glazed creosote is what turns a normal fire into a flue fire.
What a technician checks first
- Camera scan of the full flue to grade the deposit
- Whether it is brushable soot or glazed creosote
- Damper seal and smoke shelf condition
- Cap and crown, since moisture is feeding the smell
Creosote Removal
Book it soon
Air is coming down the flue instead of up
A smell coming from the fireplace → Mainly when we are using the fireplace
Odor that appears only while the fireplace is in use usually means the chimney is not establishing draft properly, so combustion gases and smells spill into the room rather than rising. In tightly sealed modern homes this is often negative pressure rather than a fault in the chimney itself.
What a technician checks first
- Flue size against the firebox opening
- Whether the house is pulling negative pressure
- Termination height above the roofline
- Any partial blockage restricting flow
Draft Problems
Call today
Most likely an animal that did not get back out
A smell coming from the fireplace → All the time, and it is getting worse · Sounds or an animal in the chimney → Nothing now — but there is a strong smell
A persistent smell that worsens day by day, with no link to using the fireplace, is the classic signature of a carcass in the flue or on the smoke shelf. In Texas heat it accelerates fast, and it will not resolve on its own. The odor saturates the masonry, so removal alone is not enough.
What a technician checks first
- Camera scan to locate the animal
- Full removal, then sanitising and deodorising the flue
- Where the point of entry was
- Capping the flue so it cannot repeat
Dead Animal Removal
Worth checking
A cold flue that needs priming — usually benign
Smoke coming into the room → At start-up, then it settles down
Smoke rolling in for the first few minutes and then clearing is typically a cold column of air sitting in the flue, resisting the rising warm air until the chimney warms through. It is common and often not a defect. It becomes worth investigating if it is new behaviour or getting worse.
What a technician checks first
- Flue temperature behaviour at start-up
- Damper opening fully and sealing when shut
- Soot build-up narrowing the flue
- Whether the termination is tall enough
Chimney Inspection
Call today
Something is restricting the flue
Smoke coming into the room → The whole time the fire is burning
Smoke entering the room throughout the burn points to a restriction — heavy creosote, a nest, debris, or a damper that is not fully opening. This one matters because the same restriction that pushes smoke into the room also pushes carbon monoxide there. Stop using the fireplace until it has been looked at.
What a technician checks first
- Camera scan top to bottom for the obstruction
- Damper travel and whether it fully clears
- Creosote grade through the smoke chamber
- Cap screen for nesting debris
Chimney Inspection
Book it soon
Wind is pushing back down the flue
Smoke coming into the room → Mostly on windy days
Trouble that shows up mainly on windy days usually traces to the termination — no cap, a damaged cap, or a chimney that finishes too low against a nearby roofline or tree. Wind crossing the opening the wrong way creates downdraft that drives smoke back into the room.
What a technician checks first
- Cap condition, height and screen
- Termination height against the roofline
- Whether a draft-correcting cap suits the flue
- Crown condition while up there
Chimney Cap
Call today
A squirrel is in the flue — most likely trapped
Sounds or an animal in the chimney → Scratching or scurrying, usually daytime
Daytime scratching and scurrying is usually a squirrel. The important part: it is rarely nesting by choice. A smooth clay or metal liner gives it nothing to climb, so it goes down and cannot get back up. Left alone it becomes a dead-animal call within days.
What a technician checks first
- Camera scan to confirm the animal and where it is
- Humane removal, live where possible
- Full nest and debris clearance
- Capping the flue so it cannot recur
Squirrel Removal
Call today
Birds or a nest in the chimney
Sounds or an animal in the chimney → Chirping, fluttering or birds
Chirping and fluttering usually means birds, and in North Texas often chimney swifts. Timing matters here: swifts are federally protected while nesting, which changes what can legally be done and when. A nest is also a genuine blockage, so the flue should not be used meanwhile.
What a technician checks first
- Identifying the species before anything is touched
- Whether an active protected nest is present
- Full clearance once it is lawful to proceed
- A cap sized to keep birds out without choking draft
Animal Removal
Call today
Failed flashing where the chimney meets the roof
Water, damp or staining near the chimney → Ceiling or wall right around the chimney
Staining on the ceiling or wall around the chimney — rather than inside the firebox — points at the flashing, the metal seal between masonry and roof. It is the single most common chimney leak we see. Water tracking there rots framing and insulation long before it becomes visible indoors.
What a technician checks first
- Flashing, counter-flashing and the seal line
- Whether previous repairs used caulk as a shortcut
- Crown and cap, which often fail alongside
- Interior extent of the water track
Flashing Repair
Book it soon
Water entering from the crown or cap
Water, damp or staining near the chimney → Inside the firebox, or damp brick indoors · Visible damage — cracks, crumbling or rust → Cracked concrete slab on top of the chimney
Damp showing up inside the firebox or on interior brick usually means water is coming straight down the flue — a cracked crown, a missing or failed cap, or both. The crown is the concrete slab on top, and once it cracks, every rain sends water into the masonry where freeze-thaw widens the damage.
What a technician checks first
- Crown for cracks, slope and drip edge
- Cap presence, fit and condition
- Whether the brick has begun absorbing water
- Interior flue for water staining
Crown Repair
Worth checking
Efflorescence — the brick is holding water
Water, damp or staining near the chimney → White chalky staining on the brick outside
White chalky bloom on the outside brick is efflorescence: salts carried to the surface as water moves through the masonry and evaporates. The staining is cosmetic. What it tells you is not, because it means water is inside the brick, and in a freeze-thaw winter that is what breaks masonry apart.
What a technician checks first
- Where the water is entering — crown, cap or joints
- Mortar joint condition
- Whether a breathable sealer suits this masonry
- Any spalling that has already started
Waterproofing
Book it soon
Mortar joints have opened up
Visible damage — cracks, crumbling or rust → Crumbling mortar or spalling brick
Crumbling joints and flaking brick faces mean the masonry is taking on water directly. Tuckpointing — cutting out the failed mortar and repacking it — stops the progression. Left long enough it stops being a repointing job and becomes a rebuild, which is a different scale of work entirely.
What a technician checks first
- How deep the joint deterioration runs
- Whether brick faces have started spalling
- Structural soundness of the stack
- Waterproofing once the joints are sound
Tuckpointing
Book it soon
The chase cover is rusting through
Visible damage — cracks, crumbling or rust → Rusted or stained metal cover on top
That metal lid on a framed chimney is the chase cover, and the cheap galvanised ones rust from the inside out. By the time rust streaks appear on the siding below, water has usually been standing on it for a while and running down inside the chase where you cannot see it.
What a technician checks first
- Whether the cover is holding standing water
- Rust-through and seam condition
- Correct slope and drip edge on a replacement
- Damage inside the chase from prior leaking
Chase Cover
Worth checking
You are on schedule — an inspection is the useful part
Nothing wrong — it has just been a while → Within the last year
Swept within the year puts you ahead of most homes in DFW. The annual item worth keeping is the inspection rather than the cleaning itself, because it catches crown cracks, flashing failures and cap damage while they are still small and cheap to deal with.
What a technician checks first
- Creosote accumulation since the last sweep
- Crown, cap and flashing condition
- Damper operation
- Liner integrity on camera
Chimney Inspection
Book it soon
Due for a sweep before the next burning season
Nothing wrong — it has just been a while → One to three years ago
One to three years of use puts measurable creosote in the flue. The standard of care is an inspection every year and a sweep whenever deposit warrants it. Booking before the autumn rush is worth doing — from October the calendar in North Texas fills quickly.
What a technician checks first
- Deposit grade through the flue and smoke chamber
- Whether it brushes out or needs rotary work
- Cap and crown while on the roof
- Before-and-after camera footage
Chimney Sweep
Call today
Overdue — do not light it until it has been swept
Nothing wrong — it has just been a while → More than three years ago, or never
Three or more years of burning, or an unknown history, is where glazed creosote becomes likely. Glazed deposit is the hard, tar-like layer that does not brush off and is the material that fuels flue fires. Worth clearing before the first fire of the season rather than after.
What a technician checks first
- Full camera scan before anything is touched
- Whether deposit is brushable or glazed
- Any damage from a past flue fire
- Cap, crown and liner condition
Chimney Sweep